Mod Podge ® 7 Piece Tool Kit
FolkArt ® Acrylic Colors – Terra Cotta, Licorice
Mod Podge ® Gloss
Mod Podge ® Shimmer - Silver
Unfinished wood 4-peg coatrack: 3½” x 23”
¾” plywood cut 12” x 24”
¼” particle-board cut 7-1/4” wide x 19-1/2” long
1 sheet scrapbook paper – gray slate pattern
4 sheets scrapbook paper – terra cotta pattern
Black and white photocopy of guitar - 7”x19”
15 large head bolts (measuring ½” across)
12 nuts to fit bolts
12 small washers to fit bolts
2 very large washers to fit bolts
30 Phillips-head screws (measuring ¼” across)
Phillips-head screwdriver (electric helpful)
Large saw-tooth picture hanger with screws
Craft knife
Drill
Ruler
Pencil
Please read and follow all manufacturers’ instructions for all tools and materials used. Provide adult supervision if children participate in this
project.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom
from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained,
Plaid Enterprises, Inc.disclaims any liability for untoward results.
Intermediate Skill Level | 3-4 Hour Crafting Time
1. Paint sides and back of ¾” plywood with Terra Cotta. Let dry.
2. Tear large pieces of the terra-cotta scrapbook papers and glue them onto the plywood front with Mod
Podge Gloss, overlapping the pieces as shown. Note: To remove air bubbles and make the paper lay flat
always rub paper with fingers while glue is wet, pressing from the center out towards the edges. Let dry.
3. Use craft knife to trim paper even with edges of the plywood.
4. Paint a coat of Mod Podge Gloss over entire board. Set aside to dry.
5. Remove pegs from coatrack. Paint entire coatrack and pegs with Licorice. Let dry. Dry-brush over the
Licorice with Mod Podge Silver Shimmer to give a gunmetal effect..
6. Cut gray slate scrapbook paper to fit top surface of coatrack. Glue on with Mod Podge Gloss. Measure
and mark where the screws will go on the coat-rack. Refer to photo. Screw into place. Note: You’ll need to
drill holes for the bolts to sit down in. Glue into holes with Mod Podge.
7. Cut the 19-1/2” length of particle-board into 3 pieces that are 6-1/2” wide. Cut guitar picture in 3 pieces to
fit.
8. Glue guitar pieces onto particleboard sections using Mod Podge Gloss. Let dry. Paint an even coat of
Mod Podge Gloss over top of 3 sections to seal and protect. Let dry completely.
9. Drill holes in each of the 4 corners of the sections of guitar picture. Insert bolt through small washer, then
through hole in corner, then tighten nut on back. Repeat for all corners.
10. Glue coatrack at bottom of board using Mod Podge Gloss. Put Mod Podge Gloss on each bolt and set
into place on board.
11. Allow project to dry flat overnight.
12. Re-install pegs of coat-rack. Screw on the saw-tooth hanger on back.
(1 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern